Calibration gas cylinder online supplier UK: Helium / argon mixtures are sometimes used for their higher heat characteristics. Gas mixtures, usually 25% helium and 75% argon are sometimes used and can help to increase travel speeds when AC – gas tungsten arc welding. Mixtures of more than 25% helium for AC – gas tungsten arc welding are used, but not often, as they can tend to produce instability, under certain circumstances, in the AC arc. Pure helium or high percentages of helium (He-90%, Ar-10%) shielding gas are used primarily for gas tungsten arc machine welding with direct current electrode negative (DCEN). Often designed as seam welders, the combination of GTAW – DCEN and the high heat input from the gas used can provide fast welding speeds and outstanding penetration. This configuration is sometimes used to produce full penetration butt welds, welded from one side only, onto temporary baking with no vee-groove preparation, just a square edged plate.
Overall, argon is a standard, low cost but high-quality choice of shielding to use when welding. Although its odourless and colourless properties make it a convenient gas to use, it can also be dangerous if leaks or overexposure when welding occurs. Never forget that you are dealing with a potentially hazardous element, so entrust installation to a specialist gas installer who knows what they are doing.
WSD (weldingsuppliesdirect.co.uk) supplies a wide range of shielding gases specifically designed to optimise performance in particular conditions. In vehicle repair and manufacturing, argon-based gas mixtures are commonly used to MIG weld carbon and low alloy steels. Argoshield Light is one of those choices. It’s ideal if you are welding thinner carbon steel ranging from 0.6 to 5mm in thickness. The addition of oxygen to Argoshield increases arc stability to minimise spatter and fast weld speeds with its low heat input reduce distortion. So it’s perfect for our earlier example where the components of a car are being painted or powder coated after welding. See more details at Span Gas Bottle.
The normal gas for TIG welding is argon (Ar). Helium (He) can be added to increase penetration and fluidity of the weld pool. Argon or argon/helium mixtures can be used for welding all grades. In some cases, nitrogen (N2) and/or hydrogen (H2) can be added to achieve special properties. For instance, the addition of hydrogen gives a similar, but much stronger, effect as adding helium. However, hydrogen additions should not be used for welding martensitic, ferritic or duplex grades. Alternatively, if nitrogen is added, the weld deposit properties of nitrogen alloyed grades can be improved. Oxidizing additions are not used because these destroy the tungsten electrode. There are no rental charges on the cylinders. A large range of Calibration Gas regulator(s) are available from stock. Carry cases to compliment the cylinders are also available. The cylinders are non-refillable.
The amounts CO and CO2 generated by fluxed processes are small and, generally, they do not present an exposure problem. The amounts of CO and CO2 generated by flame processes are also small, so the risk of over-exposure is usually low. In special cases, such as high velocity oxy-fuel gas cutting, where large quantities of gas are consumed in a short period of time, the risk of over-exposure to CO may be a problem. Source: www.weldingsuppliesdirect.co.uk.